Split Base Tee (LT)
Adaptor for Flexible Pipe (LAAM/LAAF)
Flexible Length (LLFlex)
Adjustable Length (L7A)
Lengths (LL)
Regular or Twist-Lock Tee Cap (TCS/LTC)
AluFoil Tape
ProMesh
TherMix
ProFoil
-
Split Base Tee (LT)
As the width of a masonry chimney is often restricted to a minimum, our split base tee features a removable snout. The snout is fastened to the other section of the tee from the inside of the flue. The tee cap is not included. (TCS or LTC). -
Adaptor for Flexible Pipe (LAAM/LAAF)
Used to connect flexible lengths to rigid parts. (Sold separately). -
Flexible Length (LLFlex)
Used for offsets where it is difficult to install rigid liner elbows. Made of 304 type stainless steel. The flexible length must be attached to male and female adaptors. (Adaptors sold separately). -
Adjustable Length (L7A)
Adjustable length makes it possible to adjust the liner to the required height. Telescoping from 7 to 11 inches (17.7 to 27.9 cm). -
Lengths (LL)
Five standard lengths of 6, 12, 24, 36 and 48 inches are available. They can be assembled easily to construct a chimney liner of the required height. Available in 5", 6", 7"and 8"I.D. -
Regular or Twist-Lock Tee Cap (TCS/LTC)
Used under the tee allowing the inspection and cleaning of the installation. Available in two versions: a regular cap screwed to the bottom of the tee. Or a twistlock cap featuring a longer flue and a handle to facilitate access. -
AluFoil Tape
Use to seal seams of ProFoil insulation. 2 mil aluminum foil tape has strength and adhesion. Offered in size 3"x 150'. -
ProMesh
Use to protect the ProFoil during installation. 304 stainless steel mesh slides over insulated liner. Shrinks to fit liner when pulled length-wise. -
TherMix
Use to fill space between a liner and inside masonry chimney. Ready-mix formula cures into lightweight. Semi hard mass that insulates the liner and dissipates the intense heat created in a chimney fire. -
ProFoil
Use as insulator for stainless steel liners in masonry chimneys. UL Listed insulation. Size is based on vent diameter. Required to insulate stainless steel liner to meet UL 1777 when proper clearances to chimney and framing are not available. 1"clearance from SS liner to interior wall of the masonry chimney and 1"clearance from the masonry to the house framing are required in order to meet UL 1777. If you do not have either of these clearances then a ½"wrap is required. If these two clearances are available then no insulation is needed. AluFoil Tape and ProMesh required.